OGi Modem - Hardware Guide
T401, Version .15 40 © ORBCOMM Proprietary
In this case, first confirm there is enough room from inside the asset to
thread the SMA cable connector by hand and clearance for the wrench
to apply the final torque.
Also note that the silicone used to mount the antenna must be fully
cured before the cable can be installed from the inside otherwise the
seal and mounting are compromised.
Figure 30 Apply Silicone to Terminal
8.
Place some weight on the remote antenna while the silicone cures.
CAUTION
Cable management and connector strain relief
MUST
be
incorporated in the installation. Secure the cable no more than
15 cm from the antenna enclosure and at regular intervals along
its length as part of the installation to prevent cable wear and
eliminate strain on the terminal connector. Damage to the
terminal connector interface or cable might otherwise result
leading to hardware failure.
Do Not Block These Features