9
EN
Operation/Location/Supervision
Warning!
• The device is equipped with a power adapter for
recharging the built-in rechargeable battery. The power
supply is working with a dangerous voltage, so follow the
following safety instructions and cautions:
-To charge the built-in battery, use only the supplied
accessories and the power supply supplied by the
manufacturer, or the type specified and approved by the
manufacturer of the equipment.
Charge the battery indoors only. Locate and install the
battery charging bracket so that you avoid as much as
possible dangerous situations.
- Do not expose the power supply and cord to excessive
heat, mechanical influences, water, and other liquids
and excessive moisture.
- Before each power supply connection to the power
supply, make sure the device is turned off.
-For any use, make sure the power cord is not damaged.
If you find any damage, do not use the appliance.
- Do not disconnect the mains plug from the electrical
socket by pulling the cord.
- Do not leave the mains plug connected to an electrical
outlet while the device is not in place
in the charging bracket, and the battery is not charging.
-Do not use the mains feeder if it drops on the floor, if
it shows signs of malfunction or damage, if excessive
noise noise is produced.
-If the AC power adapter is connected to the power
supply, the surface of the power supply unit may slightly
warm up while charging the battery. It is a normal
operating state and is not a fault.
-If the AC power cord or the cord with the connector is
damaged, it must be replaced by a new, corresponding
type. Replacement of the feeder for your device will be
ensured by the manufacturer, his expert service or a
qualified person.
