14
EN
Using a toothbrush
Before use, make sure the brush is correctly assembled, the brush head
is attached to the handle, and the battery is charged. Moist the brush
bristles with water and apply a paste to them.
Turn on the brush by pressing and holding button
1
for a few seconds.
CORRECT CLEANING TECHNIQUES
• We recommend that you start by cleaning the right half of the upper dental
arch from the outside. To clean, proceed from the front to the front, placing
the brush bristles at the teeth at an angle of about 45 ° in the line around
the gums.
• Move the brush to other teeth with short, slow movements.
• Once you have cleaned the outside of the right half of the upper arc, move
the brush to the inside of the dental arch.
Proceed backwards to the front again.
• Adapt the brush angle to the tooth arrangement. To clean the inside of
the front teeth, hold the brush handle vertically so that the tip of the brush
head faces up.
• Finally, clean the upper tooth surfaces.
• In the same way, clean the right half of the lower arc, the left half of the
lower arc, and finally the left half of the upper arc.
• To clean the inside of the front teeth of the lower arch, hold the brush
handle vertically so that the tip of the brush head faces down.
SETTING THE CLEANING MODE
• When the brush is turned on, briefly press button
1
repeatedly to
toggle between the cleaning modes in the order of CLEAN, SENSITIVE,
MASSAGE, WHITE and POLISH. To change the set mode, you must
press button
1
within 5 seconds of turning the brush on or the last mode
setting changed while the corresponding LED of the currently selected
mode flashes. When this time has elapsed, the LED for the corresponding
mode stops flashing, and when you press and hold button
1
, to turn off
the brush.
• The last setting used is stored. This means that the next time you turn on
the brush, it will start running in the mode that was last set.
