19
EN
Tuning and storing stations
Tuning and storing stations
1
Turn on the unit and press the
MODE
button to select the radio (FM) audio source (a
small FM indication and frequency number will appear on the display).
2
Press
7
. All available FM radio stations are automatically tuned in and stored in the
unit’s memory.
3
You can then switch the tuned and stored presets by briefly pressing the buttons
L
and
l
on the remote control.
4
To perform continuous manual tuning, hold down the
L
and
l
buttons on the unit or
remote control. Tuning starts in the appropriate direction and stops when you tune to a
station with a good signal.
5
After tuning in / selecting the desired station, turn the
VOLUME
control on the unit or
press
VOL +/-
on the remote control during playback to adjust the volume. The set
volume is shown on the display.
You can select the desired treble/bass/echo level item with the
MENU
button, then turn
the
VOLUME
control to adjust the level of the desired item. You can also make these
settings directly using the remote control and the corresponding buttons.
You can use the
EQ
button to select the desired
POP/ROCK/JAZZ/CLASICAL/FLAT
equalizer preset.
Switching preferences
In radio mode, briefly press the
L
and
l
buttons on the remote control. Switches by 1
preset in the corresponding direction (up/down).
Listening to the radio
For the best possible reception, extend the wire antenna as much as possible so that the
reception is good.
Note
When the FM mode is switched off and on again, the last station listened to is tuned in.
