Manual for Tire Pressure Monitoring Systems, TPMS
7/17
Mode 2：Single Sensor Replaced
Step
Operating Process
Photograph
1
Take off the broken sensor and replace it with a new
sensor.
2
Press both the set key and function key simultaneously
for 5 seconds. The display will flash red, and a “beep”
sound will be heard. You can release the buttons, and the
system will have entered into mode 1. Continue to
repress the function key for four times, and then the
system will switch into mode 2.
【Function】Key
【Set】Key
3
3-1
It will take about 2 seconds after entering mode 2, the
display will show “2”
3-2
Press set key to choose tire which new sensor installed,
LED will show Tire No.1 / 2 / 3 / 4.
3-3
When Tire No.1 (RF Tire) needs to be replaced, deflate
tire No.1 below 27 psi (tire low pressure default value)
and wait for the receiver to receive the signal. When Tire
No. 1 receives the signal, you will hear “beep”. Then,
start inflate tire No.1, it will keep on “beep” till Tire No.
1 is completely inflated to normal pressure.
Attention When you deflate tire, the Mazda OE sensor
will transmit the signal in about one minute.
4
After completing all the steps above, System will be back
to monitoring condition automatically.
