Manual for Tire Pressure Monitoring Systems, TPMS
6/17
Mode 1: Four Sensors Replaced
Step
Operation process
Photograph
1
The tire shop will check the tire for abrasion and rotate
tires into the appropriate position.
2
Press both the set key and function key simultaneously
for 5 seconds. The display will flash red, and a “beep”
sound will be heard. You can release the buttons the
system will have entered into mode 1
【Function】Key
【Set】Key
3
3-1
It will take about two seconds after entering mode 1, and
the display will show “1”.
3-2
When Tire No.1 needs to be reconfigured, deflate Tire
No.1 once below 27 psi (tire low pressure default), and
wait for the receiver to receive the signal. When tire No. 1
receives the signal, you will hear alarm “beep”. Then,
start inflate the tire No.1, it will keep on “beep” till Tire
No. 1 is completely inflated to normal pressure.
3-3
After finishing all the steps above, the numbers will show
“1”and turn to “2” automatically.
Attention When you deflate tire, the Mazda OE sensor
will transmit the signal in about one minute.
4
Repeat the 3-2 step above for tire No.2, No.3 and No.4
System will be back to monitoring condition automatically,
and receiver start to receive signals of tire pressure & tire
temperature.
