| Oracle Talari T3010/T5000 | Hardware Guide
The appliance power connectors are shown below. The T3010 and T5000 use 120/240 VAC.
Figure 13: Connect Power Cables to Appliance
Important Note about Cabling and Bypass Mode
When your Oracle Talari Appliance is operating in bypass mode (e.g., when it is powered off), the
appliance acts like a crossover cable. This may cause a loss of the link between the appliance and older
network devices that do not support Auto MDI-X when straight-through cables are used to connect
the LAN and WAN ports of the APNA. In such a case, a crossover cable is required from the APNA WAN
port to the older network device.
If your network devices support Auto MDI-X capability, the link should be automatically
established when the device enters bypass mode and there should be no need for crossover
cables. Talari recommends testing and verifying this capability with the appliance powered off.
For assistance, please contact the Talari Support team.
Powering Up the Appliance
Checklist for Power Up
Power up the T3010 or T5000 by performing the following steps:
5.
Determine the IP address for the Ethernet management interface.
6.
Confirm that the chassis is securely mounted.
7.
Confirm that the power and Ethernet cables are connected.
The appliance powers up automatically when first plugged in.
If you encounter problems when you power up the appliance, please see the
Troubleshooting
section of this document.
Configuring the APN Appliance
