Oracle T1200, Maintenance Manual

Page: 48 / 83

Description Setting Alarm Input DIP Switch
Position 1 - 6
All alarm cables inputs
provide monitoring.
OFF
Not Used. ON
------ 5
Not Used, set to ON. OFF
Not Used, set to OFF. ON
------ 6
Not Used. OFF
6. Re install the alarm card using Procedure — Replacing the PDP Alarm Card .
7. Reconnect all power sources to the PDP.
Replacing T1200 AS Hard Drive
The T1200 application server must be operated with the top cover in place to ensure proper cooling.
A non-skid surface or a stop behind the server may be needed to prevent the server from sliding on
the work surface.
Up to three hot-swappable hard drives can be installed in the Tekelec 1200 application server. The
front bezel must be removed to add or replace a hard drive.
Caution: If installing fewer than three hard drives, the empty bays must be populated
with drive trays that have baffles in them to maintain proper system cooling.
Note: The Tekelec 1200 application server does not support all SAS hard drives. Use only
Tekelec-approved hard drives.
To replace a T1200 AS hard drive, perform these procedures in the following order:
1. Procedure — Preparing a Hard Drive for Removal
2. Procedure — Removing the Front Bezel
3. Procedure — Removing a Hard Drive
4. Procedure — Installing a Hard Drive
5. Procedure — Replacing the Front Bezel
6. Procedure — Preparing a Hard Drive After Installation
Procedure — Preparing a Hard Drive for Removal
When a disk has been identified for removal, the bad disk must be removed from mirroring.
Note: The drive bays are numbered from right (drive 0, sda) to left (drive 2, sdc).
Before removing the bad disk, use the following command for the failed disk:
/usr/TKLC/plat/sbin/failDisk [--force] <disk to be replaced>
48 910-5680-001 Revision F, February 2014
Field Replaceable Units (FRUs) Platform Maintenance