Replacing the SFP+ Unit on the HBA
Chapter 2 • Hardware Installation and Removal
27
The following QLogic
Fast!
UTIL menu is displayed.
QLogic Fast!UTIL
Exit Fast!UTIL
----------------------------------
Reboot System
Return to Fast!UTIL
Replacing the SFP+ Unit on the HBA
The Small Form Factor Pluggable (SFP+) optics unit on this card is considered a part of the
card, NOT as a separate field replaceable unit (FRU). Therefore, in the event that the SFP
+ unit malfunctions, you must return the entire card in order to receive a replacement SFP
+ unit. Always return any malfunctioning card with the SFP+ unit attached. For information
about removing the card from a system in order to return it, see
.
Removing the Hardware
The following instructions describe the tasks required to remove the HBA. Refer to your system
installation or service manual for detailed HBA removal instructions.
The following steps summarize the hardware removal process:
1. Halt the operating system and remove power from the system.
2. Remove the HBA hardware.
To Remove the HBA
1.
Use an ESD strap (refer to
).
2.
Refer to your system documentation to shut down, power off, and unplug the
system.
3.
Disconnect all cables.
4.
Unscrew the case screws and remove the system case.