Oracle SPARC T5-8, Service Manual

Page: 171 / 206

Verify the PCIe Card
Servicing PCIe Cards 171
Related Information
■
“Determine Which PCIe Card Is Faulty” on page 155
■
“Remove a Card Carrier” on page 155
■
“Verify the PCIe Card” on page 171
Verify the PCIe Card
1. Ensure that you have completed the following:
■
Applied power to the server.
See “Connect the Power Cords” on page 191 .
■ Started the system.
See “Power On the Server (Oracle ILOM)” on page 192 .
2. Verify that the Fault LED is not lit on the PCIe card.
3. Verify that the System Service Required LEDs on the front panel and rear I/O
module are not lit.
See “Interpreting LEDs” on page 29 .
4. Verify that the System PCIe Fault LED on the front panel is not lit.
See “Front Panel Controls and LEDs” on page 31 .
5.
Perform one of the following tasks based on your verification results:
■
If any of the LEDs are lit, see “Diagnostics Process” on page 25 .
■
If none of the LEDs are lit, go to Step 6 .
6. Verify that the green Power LED is lit on the card that you installed.
7. Log in to Oracle ILOM.
See “Log In to Oracle ILOM (Service)” on page 28 .
8.
Start the
faultmgmt
shell.
->
start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)?
y
faultmgmtsp>
9.
Use the
fmadm faulty
command to determine if the server is operating normally.