Oracle SPARC T5-8, Service Manual

Page: 155 / 206

Determine Which PCIe Card Is Faulty
Servicing PCIe Cards 155
No. LED Icon Description
3 Power OK LED
(green)
Indicates these conditions:
■ Off – PCIe card is not running. You can safely remove the card or install a new card.
■ Steady on – PCIe card is powered on and is running in its normal operating state. No
service actions are required. You cannot remove the PCIe card.
■
Blinking
– PCIe card is powering up or powering down. You cannot insert or remove
the card.
4 Service Required
LED (amber
The Service Required LED indicates these conditions:
■ Off – PCIe card is operating normally.
■ On – PCIe card requires service.
Determine Which PCIe Card Is Faulty
The following LEDs are lit when a fault is detected:
■
System Service Required LEDs on the front panel and rear I/O module
■
System Rear PCIe LED on the front panel
■
Service Required LED on the faulty PCIe card
1. Determine if the System Service Required LEDs are lit on the front panel or the
rear I/O module.
See “Interpreting LEDs” on page 29 .
2. Determine if the rear PCIe LED is lit on the front panel.
See “Front Panel Controls and LEDs” on page 31 .
3. From the rear of the server, find the PCIe card that has an amber Service
Required LED lit.
4. Remove the faulty PCIe card.
See “Remove a Card Carrier” on page 155 .
Remove a Card Carrier
The server supports single-wide and double-wide card carriers. The removal steps are the same
for both carrier widths. This topic includes illustrations only for the single-wide carrier.
Note -
If you are installing a PCIe card that requires a double-wide carrier, you must remove
two single-wide carriers.