…remove the platter with the drive belt installed
-
Place one hand at the rear the motor, one hand at the front, lift the platter about 25 cm (
one inch ) and with one finger pull the belt off the motor pulley, then lift the platter straight
up.
…connect the power supply
-
Plug the supply output to the turntable input receptacle at the rear of the turntable.
-
Plug the input cord to an AC outlet.
Note: Keep the power supply away from signal carrying leads
…adjust the 33 and 45 speed
Note 1: The pitch control potentiometer is accessible through the left side cover on the function
selector module at the front of the turntable. Rotating this potentiometer will affect both speeds
simultaneously..
Note 2: The individual speed adjustment potentiometers can be reached through the motor base
from the rear of the unit.
Note 3: The inner circles of strobe marks on the calibrator disc are to be used with a supply of 50
Hz. The circle near the center is for 45 RPM, the other one is for 33 RPM. The outer circles are to
be used with a supply of 60Hz. The outermost circle is for 33 RPM, the one next to it is for 45 RPM.
-
Place the calibrator disc on the platter.
-
Select the 33 speed and check for accuracy, if a slight adjustment is required, do not
correct yet.
-
Select the 45 speed and check for accuracy.
If both speeds need to be corrected, select the 33 speed again and using the small screwdriver
supplied with the tool kit, rotate the pitch control potentiometer until the strobe mark on the
calibrator disc come to a standstill position.
-
Check the 45 speed again, if a small correction is still required , rotate the 45 RPM
potentiometer through the motor base with the small screw driver until the strobe marks
come to a standstill position.
Delphi MKIII
Owner’s manual
Summary of Contents for DELPHI MK III
Page 18: ......
