Note 4: Before installaling the spring back into the module, pull on the spring at the wider end to
strech it, this will allow it to seat well in the thread.
Step two: Preparing a spring module
Note: The upper spring damper is mounted on a nylon sleeve.
-
Install the two felt dampers in a criss-cross patter in the slotted section of the stem.
-
Install the upper spring damper over the stem.
-
Install the sorbothane damper over the spring holder and seat it well around the lip.
-
Insert the spring assembly in the suspension housing.
Step three: Mounting the module
-
Install the suspension modules on the stems over the upper spring damper.
Note 1: There are five springs supplied with the turntable which are coded as follow from the
weakest to the strongest: grey, yellow, red, green, blue. The coding is done on the inside at the
wider end of the spring. The following is the standard set up from the factory:
Grey: front left module
Yellow: rear left module
Green: right module
The red and the blue are supplied as extras.
Note 2: The standard spring combination will accommodate most tone arms.
-
Install the subchassis over the suspension modules.
-
Install the platter without the drive belt.
Step four: Calibrating the suspension.
Note 1: Before moving into this step the mat, an old record and the record clamp must be in place
on the platter.
Note 2: Do not install the drive belt nor the phono lead to prevent any bias in the interpretation of
the calibration.
Delphi MK III
Owner’s manual
Summary of Contents for DELPHI MK III
Page 18: ......
