Fuse Replacement
If the power supply is connected to the line source and the switch is in the ( ON␣ )
position the red «L.E.D. » located at the front of the unit will glow. If it does not
glow make sure the line signal coming from the wall outlet is operational.
If everything is normal, follow the procedure below to proceed to
the replacement of the line input fuse.
• Using a continuity tester check the fuse for
continuity. Continuity means « good fuse ».
No continuity means « fuse no good »
• Make sure to reinsert the fuse holder in the
same direction as the arrow inside the cover
There are 2 fuses inside the IEC socket, the one under the « O »
is the one in the signal path. The fuse under the ( – ) is a spare.
NOTE
• Close the flap until it snaps in a fully closed position
• Plug the AC power cord at the power supply end
• Switch the power supply to the « ON » position
If the fuse keeps blowing, it might be an indication of
a defective power supply unit, please contact your
dealer for advice. Do not use a different value fuse than recommended.
IMPORTANT NOTE
Fuse Types
CD Drive
- 100 to 120 volts fuse type - GMC 200ma @ 250v
- 220 to 240 volts fuse type - GMA 200ma @ 250v
CD Player
- 100 to 120 volts fuse type - GMC 2amps @ 250v
- 220 to 240 volts fuse type - GMC 1,25amp @ 250v
• Switch the power supply to the « OFF » position
• Unplug the AC power cord at the power supply end
• Use a flat blade screw driver and insert it in the
slot at the top of the IEC socket to open the
flap as shown on the picture
• Use the same flat blade screw driver to gently
extract the fuse holder
17
Summary of Contents for CD turntable
Page 1: ......
