10
350 μm
80 g/m
2
150
0
C
2
120 g/m
2
160
0
C
2
200 g/m
2
160
0
C
2
If the pouch curls up that means the temperature is too high. It is necessary to lower
it or choose higher speed.
If the pouch is not laminated that means the temperature is too low, raise the
temperature or choose a lower speed.
HOT LAMINATION
• Turn the laminator on. If the laminator is operated for the first time, press the “HOT”
button for 1 second.
• Factory settings are, temperature - 100˚C and speed number 6, these settings are
suitable for laminating 100 μm, microns pouches.
• The laminator will make a signal 3 short bleeps and show ‘READY’ on ht e display when
it reach the set temperature.
• Now you can start laminating.
• Lamination temperature can be changed by pressing the up ( ) or lowered by the ( )
down sign buttons (maximum 160˚C).
• Lamination speed can be changed by pressing the up ( ) or lowered by the ( ) down
sign buttons lamination speed 1 – 9.
• If the quality of lamination is not sufficient, press the REV button until the document
is reversed out, after 2 seconds the rollers start to move forward. Change the lamination
settings and insert document once again into the slot.
• To turn the laminator off, do not turn off by the main switch. Press the POWER button.
When the temperature decreases the powers supply will turn off automatically,
the rollers need to cool down.
COLD LAMINATON
• Turn the laminator on. Press the COLD button.
• Start lamination, when READY is displayed on a screen.
• To avoid damaging of materials like picture, it is recommended to choose COLD
lamination and use a special pouch.
4 LCD DISPLAY
TEMP:
Push the button or to increase or decrease the temperature. The scale settings
is 0 - 160°C in increments 1 degree.
SPEED
: Push the button or to increase or decrease Speed. From 1 to 9.
HOT:
Hot lamination.
COLD:
Cold lamination.
