Sideris Printer
Instrukcja obsługi
/ User guide
31
• Place the frame (17) with the tinsel/colored foil on to the two locating pins (A).
The frame has 4 holes one on each corner so the frame can be turned completely round, if
the design takes up less than 50% of the foil area, to reduce waste
for the next tinsel printing.
• Place the cover on the table in the place indicated by the frame.
• Remove the frame (17) and stick the dull side of foil on the sticky tape to hold the foil tight
without any wrinkles, then put the frame on to the cover and the locating pins (A)
• Slide the work table (6) into the equipment so that part of the document is under the tinsel
printing heater head point.
• Press the work table lock button (3). The device will move to the ready position.
• Then press the "Send" button for Silhouette Studio -
the device will start tinsel printing
.
• You can stop the tinsel printing
at any time with the pause button (5). The indicator (4)
flashes green. Pressing the button (5) again and it will resume the tinsel printing
operation.
Summary of Contents for Sideris
