10
NOTE! It is recommended to leave approx. 3mm margins all around the
document from the edge.
3. Hot lamination
• Press the [POUCHES] button on the touch panel to setup the thickness of pouch
required from the range of foil thicknesses from 75 to 250 microns. The process
of heating will start automatically.
• You can regulate temperature by using the “+” or “–“buttons on touch panel.
• It is recommended to make some tests before laminating important documents
• Open the flap at the back of equipment, insert the laminating pouch with the
document inside it into the rollers, and remember to put the sealed end first.
• If the lamination is not good you can increase or decrease temperature using „+”
or „-„ buttons on touch panel
• If you do not use the laminator continually, USE the “STANDBY” button on touch
panel. This function keeps temperature of heating elements at 80
o
C
4. Cold lamination
• Plug the equipment into the power socket and turn on by pressing the button
• To set up for cold laminating press the button [POUCHES] on touch panel and set for
cold lamination then on the display you will see this sign
✳
a snow flake.
• After hot lamination wait 40-60min to cool down the equipment before you start
to cold laminate.
Maintenance and service
• Before clearing the equipment, remove the power plug from the socket.
• If the pouch was entangled into the rollers or the laminator does not operate
correctly contact the dealer or service team.
User’s guide OPUS everLAM 330LCD
