• Use only recommended supplies and accessories.
• The equipment is designed to bind documents with the plastic combs only.
• Unpack and install all the elements of the device and put it on a sturdy and level surface.
• Before punching important documents, test the settings of the equipment on a sheet of paper.
• The equipment punches 30 sheets of paper (80 g/m
2
).
• Paper and the plastic covers must be punched separately!
• To make punching easier plastic covers can be placed between two sheets of paper. DO not
exceed max punching capacity.
• Punching dies are covered by oil to prevent them before corrosion and to provide easy start.
WARNING!
The equipment contains moving elements, keep hands and fingers away from the comb and
punching slot!
WARNING!
The punching dies are sharp.
WARNING!
Not compliance with the rules and recommendations above can void the Guarantee/Warranty.
2
MANUFACTURE’S RECOMMENDATIONS
8
3
CONSTRUCTION OF THE EQUIPMENT
Inst
rukcja obsługi /
User guide
OPUS El-Jumbo B
Construction of the equipment:
1. Opening plastic comb mechanism
2. Selectable punching dies levers
3. LED light
4. Paper side gauge
5. Waste bin
6. Paper slot
7. Foot-lever
8. Margin adjusting knob
9. Binding handle
10. Mains power switch and plug
Application
NOTE! The equipment is designed to punch paper and plastic covers, as well as to bind the documents with the plastic
comb
Operation
1. Preparation before punching
Place the equipment on a strong sturdy surface near a power socket.
Plug the equipment into the socket
Turn the equipment on by the switch next to the power socket (10) on the back of the equipment.
1. Opening plastic comb mechanism
2. Selectable punching dies levers
3. LED light
4. Paper side gauge
5. Waste bin
6. Paper slot
7. Foot-lever
8. Margin adjusting knob
9. Binding handle
10. Mains power switch and plug
