7
imAGe PreSS Device - SAfety inStrUctionS
image Press device is available in oPUS offer.
• Before putting the machine into operation please read the safety precautions, manufac-
turer recommendations and the operation manual
• the operation manual should be easily available at any time for the operator
• the machine must not be placed near the heating units or ventilation units
• the machine should not be used in vicinity of inflammable liquids or gases
• the machine may be supplied only through the original cord. a mains socket must be
provided with efficient earthing. the supply voltage must be consistent with the para-
meters specified on the technical plate positioned on the machine housing. disobeying
the above rule may result in electric shock or fire
• the supplying cable should be protected against any damage, must not be used to pull
the machine or to remove the plug from a socket
• making any changes in the electric circuit or the supplying cable may result in electric
shock
• during a long standstill or before replacing the machine, the plug should be removed
from a mains socket
• Before replacing the machine it is necessary to check if the heater cooled down in order
to avoid destroying the surface on which the machine will be placed as well as avoid the burn
8
Atlas 300 mono • User’s guide
GB
2. the bound documentation must have thickness of at least 1,8 mm (without cover). if the
documentation is thinner, it is obligatory to use filling strips (e.g. o•filling sticky avail-
able at opus), to increase the thickness of bound documents. when using channels up to
16 mm size and C sizes in C-Bind covers, put before binding both binding inserts a1 and
B1 to the binding slot and when using covers with size over 16 mm and C sizes in C-Bind
covers, put only one B1 insert into the binding slot.
3. when debinding C-Bind covers use debinding wedge included in o.CB debinding tool for
atlas 300/mB 300/mBE 300.
imPortAnt! When using AA covers put AA jig on spine of the cover.
4. Binding and de-binding of covers of the C-Bind system is performed analogous to binding
with metalbind system, but: measure the thickness of sheet pile to be bound means of the
cover selection tool and select appropriate cover.
cover
number of
dimension
bound sheets
aa
soft cover 15-40
hard cover 20-40
a
41-95
B
96-125
C
126-150
d
151-190
E
191-230
f
231-265
G
266-300
1. Choose the proper size of a
cover by using the table (on
the left) or the channel
width selecting tool (6).