8
• after work turn off the device using a main switch
• the machine is turned off completely after removing the plug from a socket
• the machine should be kept away from children reach
• danger! the machine contains heating area – pay special attention!
• the machine must not be used for any other purposes than those indicated in the oper-
ating manual
• it is necessary to check and supervise if the machine operates correctly. in case of any
malfunctions, contacting the servicing point is required
• the machine must not be located outside, should be operated in room temperature higher
than +8˚C
• Before removing any cover from the machine, the plug from a socket should be removed
necessarily
• using inappropriate lubricants causes the fire hazard
• the machine should be operated according to general safety rules
• any repairs can be conducted only by authorized staff
the image Press device was designed to make hot stampings on metalbind covers.
the use of fonts makes it possible to compose any inscription (various kinds of
fonts, also in various languages and sizes, are available) it is also possible to
prepare a special matrix (e.g. logo).
PrePArAtion to WorK
1. remove the thin guide&bind bar (8) or the thick guide & bind
bar (9) from the binding slot.
2. push the extended back support maximally to the back and dis-
assemble moving adjustable side stop (11).
3. Lift up the handle (1), move the adjusting lever (2) maximally to
the left.
4. assemble the image press device on the hooks (4) (see the pic-
ture on the left).
5. insert the plug into a mains socket.
6. turn on the switch (it is placed at the front of the housing, in the left corner). the switch
starts to light.
7. set the temperature regulator on 100˚C.
wait until the led “rEadY” lights. that means that the required temperature is achieved and
the machine is ready to work.
important!
the best results for hot stamping when using opus supplies (hot stamping foil and covers) are
obtained with the set heater temperature of 100
o
c. However, if the stamping results are
not satisfactory, a change in the settings may be necessary. in such case turn the tem-
perature regulator right (to increase the temperature) or left (in order to decrease the
temperature).
9
