CamRecord CR-S3500
Ref. 1900-SU-02-C
Page 15
2)
Boot the camera (During Boot time, the camera creates a file
with the name CAMERA_IP.CFG, CAMERA_IP.CFG shows the
actual IP address of the camera)
3)
To enter the desired camera IP address please change IP
address and Subnet mask of CAMERA_IP.CFG with a text
editor
4)
Save the file and rename it to IP.CFG
5)
Plug the stick into the camera, power cycle the camera and wait
until boot has finished.
6)
USB2 Stick can be removed once the boot is finished.
2. After setting camera and PC on the same subnetwork, the software
p
ackage “TimeViewer” can be installed.
3. When network is configured and software installed, the camera can
be operated directly:
Please connect then the GigE (Cat 6) cable to the GigE connector of
the PC and to the GigE connector of the camera.
Please note, that image data, that are stored inside the random memory
of the camera, are lost when switching off the camera by the power switch.
The camera needs a “boot”-time of several seconds.
Then start the “TimeViewer” software on your PC.
Figure 11: Camera detection
