E
nglish
30
1
2
3
4
Appendices
Replacing the Lamp
When the projector’s lamp usage reaches 1500 hours, it
displays the following warning message “Lamp may fail soon !
Replacement Suggested !” When you see this message, please
contact your local reseller or service center.
Make sure the projector has cooled down for at least 30
minutes before replacing the lamp.
Warning:
Lamp
compartment is hot!
Allow it to cool down
before replacing lamp!
Lamp Replacing Procedure:
1.
Switch off the power to the projector by pressing the Power
button.
2.
Allow the projector to cool down at least 30 minutes.
3.
Disconnect the power cord.
4.
Use a screwdriver to remove the screw from the cover.
n
5.
Push up and remove the cover.
o
6.
Remove the 3 screws from the lamp module.
p
7.
Pull out the lamp module.
q
To replace the lamp module, reverse the previous steps.
Warning:
To
reduce the risk of
personal injury, avoid
dropping the lamp
module or touching
the lamp bulb. If
dropped, the bulb
may shatter and cause
injury.
