Optoma EH460, User Manual

Page: 70 / 75

English 70
appenDICes
pJlink™ supported commands
The table below shows commands to control the projector using the PJLink™ protocol.
Command Description Remark (parameter)
Command Description Remark (parameter)
POWR Power control
0 = Standby
1 = Power on
POWR? Inquiry about the power state
0 = Standby
1 = Power on
2 = Cooling down
3 = Warming up
INPT INPT Input switching
11 = VGA1
INPT? Inquiry about input switching
12 = VGA2
13 = Component
14 = BNC
21 = VIDEO
22 = S-VIDEO
31 = HDMI 1
32 = HDMI 2
AVMT Mute control
30 = Video and audio mute disable
AVMT? Inquiry about the mute state
31 = Video and audio mute enable
ERST? Inquiry about the error state
1st byte: Fan error, 0 or 2
2nd byte: Lamp error, 0 to 2
3rd byte: Temperature error, 0 or 2
4th byte: Cover open error, 0 or 2
5th byte: Filter error, 0 or 2
6th byte: Other error, 0 or 2
0 to 2 mean as follows:
0 = No error detected, 1 = Warning, 2 = Error
LAMP? Inquiry about the lamp state 1st value (1 to 5 digits): Cumulative LAMP operating time (This item shows a
lamp operating time (hour) calculated based on that LAMP MODE is LOW.)
2nd value: 0 = Lamp off, 1 = Lamp on
INST? Inquiry about the available inputs The following value is returned.
“11 12 21 22 31 32”
NAME? Inquiry about the projector name The projector name set on the NETWORK menu or the ProjectorView
Setup window is returned
INF1? Inquiry about the manufacturer name “Optoma” is returned.
INF2? Inquiry about the model name
“XXXXX” is returned.
INF0? Inquiry about other information
No other information is available. No parameter is returned.
CLSS? Inquiry about the class information
“1” is returned.
notee:
‡ This projector is fully compliant to the specifications of JBMIA PJLink™ Class 1. It supports all the
commands defined by PJLink™ Class 1, and the compliance has been verified with the PJLink™
standard specifications Version 1.0.
‡ “XXXXX” shown in the above messages are numbers that vary depending on different models.