52
*
DVD Projector
MAINTENANCE
E
NGLISH
Replacing the Lamp
The projector displays a warning message “
Lamp is approaching
the end of its useful life in full power operation. Replacement Sug-
gested!
” When you see this message, please contact your local
reseller or service center.
Make sure the projector has cooled down for at least 30 minutes
before changing the lamp.
Warning:
Lamp compartment is
hot! Allow it to cool
down before changing
lamp!
Lamp Replacing Procedure:
1. Turn off the power to the lamp by pressing the power button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Use screwdriver to remove the screw from the cover.
5. Remove the cover.
6. Unscrew 2 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the above mentioned steps.
Warning:
To
reduce the risk of
personal injury, avoid
dropping the lamp
module or touching the
lamp bulb. If dropped,
the bulb may shatter
and cause injury.
1
2
3
4
