Optoma DLP D2+, User Manual

Page: 18 / 51

English 18
SETUP AND INSTALLATION
Effective range
Infra-Red (IR) remote control sensor is located on the front of the projector. Ensure to hold the remote control at
an angle within ±15° perpendicular to the projector’s IR remote control sensor to function correctly. The distance
between the remote control and the sensor should not be longer than 6 meters (~19.6 feet).
You can also operate the remote control by pointing it to the projected image.
Note:
When pointing the remote control directly (0 degrees angle) on the IR sensor, the distance between the
remote control and the sensor should not be longer than 8 meters (~26.2 feet).
‡ Make sure that there are no obstacles between the remote control and the IR sensor on the projector
that might obstruct the infra-red beam.
‡ Make sure the IR transmitter of the remote control is not being shined by sunlight or fluorescent lamps
directly.
‡ Please keep the remote controller away from fluorescent lamps for over 2 meters or the remote
controller might become malfunction.
‡ If the remote control is close to Inverter-Type fluorescent lamps, it might become ineffective from time
to time.
‡ If the remote control and the projector are within a very short distance, the remote control might
become ineffective.
‡ For Bluetooth pairing, after powering on the projector, make sure to aim the remote control to the area
marked with a red circle on the image below.
‡ If the standby Power Mode is set to “Eco”, after powering on the projector, make sure to aim the
remote control to the IR receiver directly.
Approx. ±15°