ELECTRIC CONNECTION
Remove two pulling locks on the bottom bar first before
any operation. this is important to prevent motor damage.
OPERATING INSTRUCTION:
Plug in power supply.
For Switch control: Plug in Switch into switch jack. Press
button to Up position, screen goes up. Press button to stop
position, screen stops. Press button to down position, screen
goes down.
For IR Remote: Direct the handset to IR window on
screen housing. Press the Up/Stop/Down button on the hand
set, screen goes Up/Stop/Down accordingly.
For 12V trigger: Input 12V trigger signal, screen goes
down. Stop this signal, screen goes up.
Electric lock: Press the Up & Down buttons on the IR
handset together, then all Up & Down buttons on the switch
and IR handset will be locked. To be unlocked press Stop
button on the IR handset again or unplug the power supply
and plug in again.
Keeping the screen rolled in its protective case when not
in use. Always examine both front and back of surface before
re-rolling into case to make certain screen is free of dust, dirt
or other foreign matter.
Internal wiring has been completed at the factory.No
additional wiring is necessary.
Note:all wiring related to the screen,may only
be serviced by a manufacturer approved trained
electrical technician.Tampering with electrical
wiring may void warranty and release Panoview
of liability.
