Thank you for choosing Panoview screens. All screens
have passed the strict quality inspection before delivery.
Read this manual carefully to ensure proper usage.
Important Attention:
the installation of the screen,
the electric wire connection, the setting of the limit switches
must be made by a trained engineer only
Motorized screen with IR remote control, switch control & 12v trigger port
Technical data:
Input Voltage: 120VAC/60HZ
Output Voltage: 3A
Fuse: 1A
IR Remote Control Distance: ≤8m, ±15°Horizontal
12V Trigger Jack: OD3.4xID1.3
12V Trigger Signal: Voltage:7---11VAC or 8---16VDC, Current: ≥2mA
IR Handset: 1pc
Switch control: 1pc
SETTING THE DOWN LIMIT POSITION
To reduce screen drop:
Make sure middle fasten screw (F) is loosened,then
loosen small right fasten screw (FR) .Turn right screw (RS)
counterclockwise to decrease the amount of screen
drop.Run the screen down to test the stop position.If the
screen drops too far,adjust the limit switch again.Repeat
until the desired position is set.When complete,fasten
middle fasten screw (F) and small right fasten screw (FR).
To increase screen drop:
Make sure middle fasten screw (F) loosened,then loosen
small right fasten screw(FR),turn right screw (RS) clockwise
to increase the amount of screen drop.Run the screen
down to test the stop position.If the screen does not drop
enough,adjust the limit switch again.Repeat until the
desired position is set.When complete,fasten middle fasten
screw (F) and small right fasten screw (FR).
SETTING THE UP LIMIT POSITION
CAUTION: Do not allow the slat bar to become wedged
between the roller and case. This could damage the fabric
and motor.Always check that the slat is free to move inside
the case.
Screen travels into case too far:
Make sure middle fasten screw (F) loosened,then loosen
small left fasten screw(FL).Turn left screw (LS) clockwise to
decrease the amount of travel.Run the screen up to test the
stop position.If the screen does not stop properly,adjust the
limit switch again.Repeat until the desired position is set.
When complete fasten middle fasten screw (F) and small
left fasten screw (FR).
SWITCH BOX
PLUG
SWITCH JACK
12V TRIGGER
