3
6
Unpack screen carefully, be sure screen is in good condition,
and check that all accessories are included inside carton.
Care in mounting and care in correct operation will mean a
long and satisfactory life for your Panoview screen. Locate the
screen where the audience can best see it and where other
furnishings in the room permit.
Check that voltage and frequency marked on screen is in
accordance with local power utility. It is suggested only to use
screen indoor under normal temperature and humidity
conditions.
Remove two pulling locks on the bottom slat bar after the
case has been installed.
Install screen brackets onto ceiling or wall with appropriate
hardware.
Anchor screen onto bracket as shown in above figure below.
MOUNT SCREEN TO WALL
MOUNT SCREEN TO CEILING
SCREEN ADJUSTMENT
Note: Adjustments to screen limit positions, can only
be performed by a trained technician.
Screen travel is stopped automatically in the down and up positions
by limit switches that are preset in the factory. If it is necessary to adjust
for more or less, please follow the steps below for adjustment.
Disconnect the power supply first before any operation.
Remove the plate on right bottom side of screen housing.
This is important.
Loosen Fasten Screw(F) first before adjustment,
Upper limit switch is on the left side and bottom limit is on the right
side.
Tighten Fasten Screen( F) after all adjustment.
PLATE
LEFT SCREW(LS)
RIGHT SCREW(RS)
FASTEN SCREW(F)
FL
FR
