A23.0910
www.optoedu.com
Page 8 of 14
Fig. 10
Fig. 11
Fig. 12
2-2-7
Assemble the Clip
1)
Use the clip to avoid the specimen moving.
2)
Insert the clip
①
into the two holes of the base, as the
arrowhead direction shown in the figure. (See Fig. 10)
2-2-8
Fix the Microscope Body Position
1)
Loosen the lock knob
①
, and rotate the microscope
body and the focusing bracket group left and right.
2)
Match the center of zoom body group with the center
of worktable, then lock the lock knob
①
. (See Fig. 11)
2-2-9
Connect the LED Light Source and Power Cord
1)
Make sure the main switch is at “O” (OFF)
position.(See Fig. 12)
2)
Insert one end of the optical fiber
①
into the inner
hole
②
of the power supply box to the bottom, and align
the flat surface with the lock screw
③
, then lock it with
the lock screw
③
.
3)
Insert the other end of the optical fiber
①
into the
hole of the base
④
, then lock it with the lock screw.
4)
Insert one end of the power adapter
⑥
into the inner
hole
⑤
of the power supply box.
5)
Insert one end of the power cable
⑦
into the
corresponding hole of the power adapter
⑥
, and the
other end into the power supply socket.
★
The power supply box supports wide voltage as
100-240V.
★
Don’t use strong force when the power cord is
bended or twisted, otherwise it will be damaged.
★
Use the special wire supplied by our company. If
it’s lost or damaged, choose one with the same
specifications.
★
Connect the power cord appropriately to make
sure the instrument is connected to ground.
