9
2-2-4 Assemble the objectives (See fig.6&fig.7)
1.
Rotate the coarse focusing knob
①
, until the
condenser is in low-limit location.(See fig.6)
★
The condenser is set to the lowest location when
exworks, to make the instrument safe in transit.
Please turn the adjusting ring
②
of the coarse
adjustment knob to the proper tension. (See fig.6)
2.
Install the objective into the microscope nosepiece
from the lowest magnification to the highest in a
clockwise direction from the rear
.
◎
It is easy for use according to doing this assemble
method.
◎
It could be also assembled by aperture on the stage.
★
Clean the objectives periodically, cause the
inverted microscope objective is sensitive.
★
Cover the hole on the condenser with the dust
cap
③
to avoid the dust and the dirt. (See fig.7)
★
Search and focus the sample by low magnification
objective(4X or 10X) when using the equipment.
Then change to the high magnification ones
according as the situation observation requires.
★
Turn the condenser when changing the objectives,
and make sure the objective is shift in the light
path until here a “click”.
2-2-5 Assemble the Stage extension board/
Attachable mechanical stage (See fig.8)
◎
Stage extension board could assemble on both left
and right to extend the work stage. But the stage
extension board and the attachable mechanical stage
can not use at the same side.
◎
Attachable mechanical stage generally assembles on
the right. It would be operated more comfortably to
do so.
1.
Assemble stage extension board
Screw the lock-screw
①
on the stage extension
board, then screw it from bottom right or bottom left,
and use small tools to screw it down till the board is
fixing firmly.(See fig.8)
2.
Assemble attachable mechanical stage
Assemble it as the stage extension board.
Fig 6
Fig 7
Fig 8
