UP-67ETH, UP-127ETH,
UP-247ETH, UP-367ETH
Digital power unit
UP-x7ETH version 1.1
23
6.
INSTALLATION OF AN AMPLIFIER
To install an UP-ETH, proceed as follows:
1.
By means of the P.A. Manager software, add the power unit to the installation. Refer to section 6.1.
2.
Configure the parameters of the amplifier (General, Audio, I/O Contacts and Temperature Control
tabs). Follow the instructions in section 6.2.
3.
Connect the unit to the installation structure. Refer to section 6.3.
4.
Configure the IP address and make the connections. Refer to section 6.4.
5.
Send configurations to the amplifier. Refer to section 6.5.
6.
Configure the noise sensors. Refer to section 6.6.
7.
Configure the surveillance of the amplifier. Refer to section 6.7.
If the amplifier is already configured, connect it and it will be operative as soon as switched on.
a)
If the installation has a Server PC, the amplifier will download the configuration variations from the
Server PC in the installation.
b)
If the installation does not have a Server PC, when switched on, the amplifier will use the
configurations of its local memory.
6.1. Configuration of the amplifier in the installation by means of the
P.A. Manager software
To configure the unit, it is necessary to have a PC connected to the network that has the SCF-01 or SCM-
01 (P.A. Manager) software.
1.
If the software is the SCM-01, start the application, open the
Options
menu and select
Installations
(administrator user level is required). If the software is the SCF-01, start the application.
N.B.: Prior to configuration of the parameters of the amplifier, it is necessary to have configured the
parameters of the installation and the PA areas.
2.
From the installation display, click on the PA area to which you wish to add the power unit.
3.
Open the menu
Add Equipment
, and select the power unit model that you wish to add (
UP-36xETH
,
UP-24xETH
,
UP-12xETH
or
UP-6xETH
). The equipment configuration screen appears.
4.
Refer to section
6.2. Power unit configuration parameters.
