OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.0.1 dated 2015-12-17
Page 62
Original operating instructions
MH25V
GB
3.3.2 Load suspension point
WARNING!
Danger of crushing and overturning. Proceed carefully when lifting, installing and
assembling the machine.
Fix the load lifting gear around the drilling-milling head. Use a lifting sling for this purpose.
Lock all clamping levers on the drilling-milling machine before you lift it.
Make sure that the attached load does not cause damage to components or paint.
3.3.3 Assembly
Check that the milling machine foundation is horizontal with a spirit level.
Check that the foundation has sufficient load-bearing capacity and rigidity.
ATTENTION!
Inadequate rigidity of the foundation will cause interaction of vibrations between the
milling machine and the foundation (resonant frequency of the components). If the
rigidity of the overall system is insufficient, critical speeds with annoying vibrations will
be reached very quickly and lead to bad milling results.
Place the milling machine on the provided foundation.
Fix the machine base to the substructure through the holes pre-drilled for this purpose.
WARNING!
The nature of the foundation and type of fixings used to secure the machine base to the
foundation must be capable of absorbing the loads caused by the milling machine. The
foundation must be level. Check that the milling machine foundation is horizontal by
using a spirit level.
Fix the milling machine to its foundation at the recesses provided on the machine base for this
purpose. We recommend that you use shear connector cartridges or heavy-duty anchors.
