OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.1.6 dated 16. October 2014
Page 110
Original operating instructions
828D Network
GB
10.7
Network
10.8
Data interfaces and current collection
When connecting data interfaces make sure that the data cable runs to the interface of the con-
trolwithin shortest possible distance. The cable routing can be conducted along the measuring
system lines. However the cable in the switch cabinet must never be routed nearby the drive
apparatuses of the NC axis or the frequency converter itself. Errors occur during data transfer
due to electromagnetic radiation (EMC-problems).
The control is equipped with the following data interfaces. They are located laterally on the con-
trol panel of the CNC-maschine:
RJ45 plug- in connection
USB connection
Power connection (socket for current supply (230V) e.g. for a notebook)
Img.10-11: Data interfaces and current collection
10.9
Installation and network connection
INFORMATION
Note the level of access
in order to call the menu shown below.
In order to install on the network connection it is necessary to execute the following steps.
Press the key <Menu Select> and then the softkey "Setup".
USB interface
Network connection
Socket for current collection (230V) e.g. for a notebook
Warning!
Do not use any devices which require more than 2 A cur-
rent!
Setup
Machine
Parameter
Program
Program
manager
Diag-
Setup
Machine configuration
Machine Axis
Identifier
Drive
Name
Index
Type
No.
Type
Channel
Motor
Spindle
Linear
Linear
Linear
nostics
