Operation
Version 1.1.6 - 2021-9-17
29
Translation of original instruction
TU3008G
GB
T
U
3008G
_GB
_4.
fm
4.4
Switching the machine off
Press push button "Off" or set the rotation direction switch to the neutral central position.
If the lathe has been shut off for a longer period of time, switch it off using the main switch
and secure it against being unintentionally switched on again or pull the power plug.
Disconnecting and securing the lathe on page 15
CAUTION!
The emergency stop button may only be activated in an emergency. You should not use
the EMERGENCY STOP button to stop the machine during normal operation.
4.5
Resetting an emergency stop condition
Unlock the emergency stop button again.
Set the rotation direction switch to the neutral central position.
Select turning direction.
Switch on spindle rotation.
4.6
Resetting the motor circuit breaker
When the motor has been overloaded.
Activate the motor circuit breaker again. Press the reset button.
INFORMATION
Make sure that the cutting forces are not too large. The motor circuit breaker triggers
before the three-phase motor stops due to overloading, or the V-belt slips through
overload and burns. The motor circuit breaker is adjustable. You get the highest torque
on the spindle at the lowest speed.
CAUTION!
The setting of the motor circuit breaker may only be performed by a qualified electrician.
If the V-belt slips and the motor circuit breaker is not tripped, the setting of the motor
circuit breaker is incorrect.
V-belt check, re-tighten on page 71
Incorrect operation due to high cutting forces in connection with an incorrect setting of
the motor circuit breaker, cause damage to the electrical system and the V-belt.
4.7
Power failure, Restoring readiness for operation
Set the rotation direction switch to the neutral central position.
Select turning direction.
Switch on spindle rotation.
Reset button
