OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.0.4 dated 2015-11-19
Page 21
Original operating instructions
DRO 5
GB
4.2
Operations
4.2.1 Axial function
In the normal display state, press (X,Y, Z) key to make the corresponding axial value flash. After flash sev-
eral times, this axis will be cleared.
If the value of the indicator is blinking, press the corresponding axis button again to cancel the operation.
If the displayed value is in flashing state, press again the function button "PROG" in order to change the
fundamental value of the axis.
4.2.2 Modification of the basic value of X, Y, Z
After entering this option, the basic value is highlighted, and the digital bit is located in the flashing state.
The
↑
↓
keys are used for changing the digital bit, the
←
→
keys are used for selecting the digital bit. After
completing the changes, press the "PROG" key to exit the option.
5
MENU
The operating modes of the menus are nearly same. The
↑
↓
key move the cursor to the specified options,
the "PROG" key is used to select. For optional items, using
↑
↓
key to select, and using the "PROG" key to
exit after completing. For modifying items,
using
↑
↓
key to modify the digital bit, using
←
→
key to select the digital bit, using "PROG" key to exit after
completing. Pressing the "PROG" key in multilevel menus enters the next level menu.
5.1
The main menu
In the normal display state, press and hold the "PROG" key for three seconds to enter the main menu.
LCD display setting
LCD display setting: the secondary menu, press "PROG" key to enter to modify the LED display parameter.
Unit selection
Press "PROG" key to enter the menu, mm/inch as a select.
Language selection
Press "PROG" key to enter the menu, English/German as a select.
Working mode
Press "PROG" key to enter and select,
X Y/Z0 Z
Standard display
X Z+Z0 Z
for lathes, Z / Z0 axis overlay display, Sum of be top slide
2X Y/Z0 Z
for lathes, duplicate value in the X axis display.
Decimal point
Selection of decimal places, 2 or 3 decimal places.
Channel setup
Multilevel menus, press the "PROG" key to enter the menu, to modify X Y Z as well as the speed axial
parameter.
