Assembly
Version 1.1.8 dated 2018-9-13
Page 72
Translation of the original instructions
B16H | B16HV
GB
B16H_B
16HV_
GB_
3
.f
m
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
The substructure must be suitable for the bench drilling machine. Also make sure that the
floor has sufficient load bearing capacity and is level.
The substructure must be prepared in a way that possibly used coolant cannot penetrate
into the floor.
Any parts sticking out such as stops, handles, etc. have to be secured by measures taken
by the customer if necessary in order to avoid endangerment of persons.
Provide sufficient space for the staff preparing and operating the machine and transporting
the material.
Also consider that the machine is accessible for setting and maintenance works.
Provide for sufficient illumination (Minimum value: 500 lux, measured at the tool tip). At little
intensity of illumination an additional illumination has to be ensured e.g. by means of a sep-
arate workplace lamp.
INFORMATION
The mains plug of the bench drilling machine must be freely accessible.
3.3.2
Assembly of the drilling machine
WARNING!
Danger of crushing when assembling and installing the machine components.
INFORMATION
The drilling machine is delivered premounted.
Only put up the drilling machine at the installation site and pin up the drill chuck on the seat
cone.
3.4
Installation
Check the horizontal orientation of the base of the bench drilling machine with a spirit level.
Check if the underground is sufficiently stable and rigid.
Position the bench drilling machine on the intended foundation.
Fix the bench drilling machine in the provided through-holes on the machine foot.
WARNING!
The condition of the underground and the fixing type of the machine foot to the
underground must be in a way that it can bear the loads of the bench drilling machine.
The underground must be level. Check if the underground of the bench drilling machine
is level using a spirit level.
3.4.1
Fixing
In order to provide for the necessary stability of the drilling machine,
it is necessary to firmly bolt the base of the machine to the subsurface.
We recommend you to use shear connector cartridges resp. heavy-duty anchors.
