Instructions for Use and Maintenance 151-191 (1310)
trejonindustries.se
20
Breddningsvingen
monteras på
insidan av
maskinen
We advise you against using this equipment as a plough. Always let the equipment work its
way through the snow with the cutter turning. When clearing great masses of snow you should
work yourself through in two runs.
When operating in wet and heavy snow, more power is needed, and the equipment needs to
be used with high revs before working on the snow. If you should come to a halt, stop the
tractor, lift up the equipment, back up a bit, let the equipment down, and try again. Should
there be an obstruction in the ejector tube, the tractor and the PTO must be stopped before
the equipment is cleaned. Inform anybody in the vicinity that work is going on with the
equipment. Drop the ejector tube and clear the obstruction.
When using the equipment for the first time in the cold season, you should set it to lean back a
little. This will ensure that the wearing edge does not pick up a lot of stones and debris that
can be ejected dangerously. After a while as the road has become hard, you can set the
equipment to a more aggressive angle.
Reversing and front mounted
If the snow blower is mounted in the front of the tractor or at the rear of a reverse drive tractor
the snow blower should to be equipped with a protective bow in the front. The bow is available
as optional equipment. Fit the shear bolt clutch side of the PTO-shaft facing the tractor (A
wrongly mounted PTO shaft can result in a breakage of the drive shafts).
