Instructions for Use and Maintenance 151-191 (1310)
trejonindustries.se
16
Breddningsvingen
monteras på
insidan av
maskinen
Attach the machine at a hard level surface.
Attach tractors lifting arms to lower connection points at machine, and there after the top link,
(choose connection points that make lifting arms and top link as parallel as possible, all to
make machine levelled during lifting)
Turn of tractor’s engine and apply the hand brake.
Adjust the length of the PTO shaft. Pull the shaft apart, and fit the end with the shear pin and
mounting flange on to the tractor. Check that the shaft does not bottom out in any position,
(min. play 30mm) and that the sliding part is sufficiently seated in the cuff part (min. 300 mm)
*
.
If not, shorten the shaft. See the instructions that came with the shaft, (trim any cutting edges
of , to avoid damages on pipes when telescoping). Try to attain longest possible shaft overlap.
Be extra careful with shaft overlap when using hydraulic top link, when this equipment can
make quick changes at measure. Note that usually the shaft is shorter when mounting at the
front than when mounting at the rear.
*Alternative for PTO-shafts shorter than 1000mm, use at least half of maximum overlap.
When used on a reversing tractor and when mounted on the front, the shear bolt clutch must
always be closest to the tractor. A wrongly mounted PTO shaft can result in a breakage of the
drive shaft.
Use the chains to fasten the PTO-
shaft guards, so they don’t rotate.
Lock lifting arms sideways with the stabilizer rods.
Attach hydraulic hoses for ejecting pipe control to double acting outlets at tractor. Clean the
connections carefully before attaching. Before using the equipment, test the operation of the
ejector pipe control.
Check that machine can work freely from tractor in all predictable situations.
