Opticon
OPR 3001
Specifications Manual
19
The scanner stays ON (is able to receive data) except during certain parts of
the process, such as receiving data (buzzer command execution), transmitting
data, and menu processing. The scanner checks the CTS line before
transmitting data. When it is ON, the scanner transmits data. When it is OFF,
the scanner waits for it to turn ON within a set time. The scanner will abort
transmission with an error indication (buzzer) when the CTS line is not ON
within a specified period. The Flow Control time-outs are as follows, and the
default setting is “indefinitely“ (I0).
Flow Control Time Out
Menu/Command
Indefinitely I0
100 ms
I1
200 ms
I2
400 ms
I3
CTS, TxD signal timing
When the CTS line is turned OFF while sending a TxD signal, the scanner transmits one character and waits.
When the RTS signal is turned ON while transmitting a character, the character will be transmitted.
Figure 14: Signal timing
Note: When using loopback (wire connection) for CTS, RTS line of the scanner in this setting,
No handshake
is not enabled.
Figure 13: Cannot receive command