Welcome!
Congratulations on your purchase of the two (2) fibers DisplayPort extender,
DPFX-250-TR. This manual contains information that will assist you in
installing and operating the product.
Product Description
A compact optical DisplayPort extender, DPFX-250-TR enables to transmit 4K
(4096x2160) at 60Hz signal up to 200m (656feet), avoiding any tricks like
scaling or data compression for lessening a burden of data transmission. It
provides total data throughput 21.6Gbps (5.4Gbps per lane).
The OM3 fiber connection by two (2) LC fibers connector between transmitter
and receiver, gives clean, secure and easy installation with perfect electrical
isolation, but without electrical hazard and interference. The DPFX-250-TR can
be operated by either USB power by plugging the USB cable or 3.3V from pin
#20 of DisplayPort interface.
Figure 1
– Overall Connection of DPFX-250-TR
1-1 Welcome, Product Description
System Requirements for Setup
□
Hardware requirements
▪
You must have a DisplayPort source and display. It should
support the maximum graphic resolution feature of displays to
be connected.
▪
No special requirements of memory size, CPU speed and
chipsets, if you’ve already properly installed your DisplayPort
systems or graphic cards.
▪
Proper initial trial of the entire platform with its application using
a short length copper cable is recommended prior to installation
with the optical link.
□
Software requirements
▪
No
special restrictions, if you’ve already properly installed your
DisplayPort systems.
□
Power Technical Advisory
▪
Enclosed Power Adaptors and USB cables supply power to both
Transmitter and Receiver.
□
Connection Advisory
▪
It is highly recommended that DisplayPort source is directly
connected into DisplayPort display output via DPFX-250-TR
without connection to incompatible distributor, switcher
and selector.
The Shipping Group of
DPFX-250-TR;
One (1) Transmitter (Tx) and One (1) Receiver (Rx)
One (1) 0.2m Male to Female DisplayPort copper cable
Two (2) Micro USB to USB cables
Two (2) 5V 1A power adapter
User Manual
※
Default connection is direct connection to both source (Tx side) and
display (RX side)
※
If direct connection is impracticable, 0.2m DisplayPort copper cable
is strongly recommended to use on TX(Display Source) side only
1-2 System Requirements for Setup
DPFX-250
TX
DPFX-250
RX
