Troubleshooting
The display shows only black screen.
- Ensure that all plugs and jacks used by external power supplies (both
Opticis and others) are firmly connected. Ensure that the Power and status
LED ON.
- Ensure that the video ports are firmly plugged in to the source and display.
- Ensure that the converter and receiver modules plugged correctly to the
source and display, respectively.
- Check if the source and display are powered on and properly booted.
Screen is distorted or displays noises.
- Check if the graphic resolution is properly set. Go to the display properties of
Windows and tap the settings.
- Ensure that the resolution sets less than 1080p (1920x1080) at 60Hz refresh
ratio.
- Reset the system. Disconnect and reconnect the optical fiber or 5V power
adapters.
Maintenance
No special maintenance is required for the converter and power adapters.
Ensure that the converter and power adapters are stored or used in a benign
environment free from liquid or dirt contamination.
There are no user serviceable parts. Refer all service and repair issues to
Opticis.
Technical Support and Service
For commercial or general product support, contact your reseller. For
technical service, contact Opticis by email
or visit its
website at www.opticis.com
1-5 Troubleshooting, Maintenance, Technical Support
Note1:
The maximum extension length by multi-mode fiber is 500 meters.
Note2:
Be recommended NOT to use any intermediate cable or adapter in
between to avoid undesirable performance degradation.
Figure 1
– Connection Diagram of CNDF-200
1-4 Installation
Local
Component video Display
One (1)
Optica
l F
iber
DVFX-100
Rx
Remote
DVI Display
Up to 108
0p
CNDF-200
Component
video Source
