Optical Systems Design OSD139HS, Operator'S Manual

Page: 8 / 16

OPTICAL SYSTEMS DESIGN
DOC ID: 10117202
OSD139HS OPERATOR MANUAL
Page 8 of 16
2. INSTALLATION AND OPERATION
2.1 INTRODUCTION
This section outlines the methods required to install and operate the OSD139HS successfully. This
information should be studied carefully if damage to the equipment or poor results are to be avoided.
This equipment has been fully tested prior to dispatch and is ready for immediate operation. However, it
is advisable to check for external transportation damage prior to operation. If damage is detectable,
return the unit and the packaging to the supplier.
2.2 INSTALLATION
2.2.1
WARNING AND PRECAUTION
▲
ELECTROMAGNETIC COMPATIBILITY
This is a Class B product.
▲
OPTICAL OUTPUT OPERATION
WARNING : Laser Safety: Class 1 Laser Product per IEC/EN 60825-1:20011 standard.
Class 1
The OSD139HS is a Class 1 laser product.
PRECAUTIONS
▲
All service personnel should be provided training as to the hazards of direct viewing of laser
radiation and of the precautionary measures during servicing of equipment
▲
Areas where laser products are installed should be restricted in access to trained service
personnel only and appropriate warning signs posted in the work area.
▲
All laser apertures should be covered by protective covers when not connected to optical
fibers. Never leave outputs uncovered.
▲
Laser equipment should be positioned above or below eye level where possible. Apertures
should be positioned away from personnel.
▲
Protective eyewear should be worn in the vicinity of laser equipment.