If the 15QR lever tension is either
too
loose
or
too tight
when the 15QR
lever is positioned between one (1)
and twenty (20) mm forward of the
fork leg when closed, use the
following procedure to correct this.
Note the axle number, which is the
number at the indicator arrow.
Use a 2.5 mm hex wrench to loosen
the axle nut keeper screw
approximately 4 turns, but do not
completely remove the screw.
Move the 15QR to the open position
and unthread the axle approximately
4 turns.
Push the 15QR axle in from the open
lever side. This will push the axle nut
keeper out and allow you to rotate it
out of the way.
Continue to push on the 15QR axle
and turn the axle nut clockwise to
increase the lever tension, or
counter-clockwise to decrease the
lever tension.
Return the axle nut keeper into place
and torque the bolt to 0.90 Nm (8 in-
lb).
Repeat the axle installation
instructions to verify proper
installation and adjustment.
52
Optibike R8C and R15C Manual
