5.RECORDING
5-1.Description for Recording
5-2.Recording Method
-6-
The VX-402REC detector records warning messages by either of two different ways: speak direct to its
built-in microphone or connect an external sound source (tape-recorder or computer etc.) to the detector.
1
2
4
5
Set the detectorís recording
level volume for max.
Connect the earphone, headphone jack or
line out jack of the external sound source
with the detector's jack using connection
cable with
monaural
plugs.Set the
detector’s recording level volume for min.
Choose track A or track B on which to record.
* To record on track A (track B), set DIP switch B-3 (4) for active.(See page 9.)
Speak a message to the
microphone.
*Speak loud enough to blink the
recording level indicator.
Play back a desired message/sound on the
sound source and adjust the detector’s
recording level volume so that the recording
level indicator may blink.
When recording is completed, the detector automatically plays back the recorded
message/sound. Listen to check if the sound volume and quality are satisfactory.
If not, go back to step 3 above and repeat the procedure thereafter.
Recording Level Indicator
Recording Level Volume
Recording Start Switch
External Input Jack
Microphone
Voice Mode Switch
Voice Volume
Day/Night Message:
Armed/Disarmed:
Sequential Message:
Pre-Warning:
MIN.
MAX.
Microphone
Sound Source
IMPORTANT
•Do not record big volume from the beginning, which could overload and damage the speaker.
•Do not record the sound of chimes or a siren, which could overload and damage the speaker.
•For connection with sound source, use the plug which suited for the jack form of the apparatus.
•A blinking recording level indicator shows that an adequate sound volume has been ensured.
If reproduced sound is heard broken, adjust the sound level with the detectorís recording level
volume or the sound source’s volume controller.
3
Press the recording start switch.
* The detector can record while its LED indicator blinks approx 8 seconds.
123
4
alarm shop
