Memory Function
[Recording / MEM. mode]
q
Press and hold MEM./
쑴
button for two seconds or more to record the tem-
perature value displayed at the time when you start pressing the button. Memory
function is available in Normal Measurement mode, Continuous Measurement
mode or HOLD mode (refer to page 8).
w
When the temperature data is recorded, "
MEM
" sign and the
memory number (01 to 99) on LCD display blink.
e
A maximum of 99 points of temperature data can be recorded
in the memory.
r
When you try to enter the memory over 100 points, the dis-
play shows "
FULL
".
[Recalling / CALL Mode]
q
Press and hold CALL/
쑶
button for two seconds or more in
HOLD Mode (refer to page 8), and "
CALL
" sign appears on the
LCD display. In CALL (recalling) mode, the last record of tem-
perature data and the corresponding memory number are shown
on the display.
w
By pressing MEM./
쑴
or CALL/
쑶
button, you can select the
memory number to show the stored temperature value corre-
sponding to the memory number.
e
To quit CALL mode, press SET/ENTER or MEASURE button.
You can enter HOLD mode by pressing SET/ENTER button, or
Normal Measurement mode by pressing MEASURE button.
* To erase all the stored records, see "Record Erasing" on page 14.
The non-contact thermometer PT-5LD can store 99-point temperature data in memory. Operate ac-
cording to the following procedure:
10
Ramco National
800-280-6933 | [email protected] www.optex-ramco.com
All manuals and user guides at all-guides.com
