Detection area settings and walk test
4
Step
1
2
Caution
Do not use the vertical angle adjustment of the main unit other than adjusting
the detection area surface to be parallel to the ground inclination.
Parallel Adjusting the detection range
Remove the Back cover by hand.
Raise the Back cover up.
Pull it back.
Adjust PIR area direction
Angle can be adjusted with either left or right screw.
4-1. PIR area direction
1
2
The display of the detection area helps to set the area.
- 6 -
Settings on the InSight web
It is possible to refer the location of the detection area following procedure.
SETUP -> PIR DETECTOR -> PIR area viewer
In this step, do not change the camera tilt angle on InSight web settings.
Horizontal ±95°
Vertical 0° to -20°
1
2
NOTE
IP camera settings
