Optelecom-nkf XSNet 2800 SW User Manual Download Page 25

Page: 25 / 25

13. Safety, EMC, ESD

General

The safety information contained in this section, and on other
pages of this manual, must be observed whenever this unit is
operated, serviced, or repaired. Failure to comply with any
precaution, warning, or instruction noted in the manual is in
violation of the standards of design, manufacture, and
intended use of the unit.
Installation, adjustment, maintenance and repair of this
equipment are to be performed by trained personnel aware of
the hazards involved. For correct and safe use of the
equipment and in order to keep the equipment in a safe
condition, it is essential that both operating and servicing
personnel follow standard safety procedures in addition to the
safety precautions and warnings specified in this manual, and
that this unit be installed in locations accessible to trained
service personnel only.

Optelecom-NKF assumes no liability for the customer’s
failure to comply with any of these safety requirements.

UL/IEC/EN

60950-1: General safety requirements

The equipment described in this manual has been designed
and tested according to the UL/IEC/EN 60950-1 safety
requirements.

If there is any doubt regarding the safety of the equipment, do
not put it into operation.

This might be the case when the

equipment shows physical damage or is stressed beyond
tolerable limits (e.g. during storage and transportation).

Before opening the equipment, disconnect it from all power
sources.

The equipment must be powered by a SELV

power

supply.

When this unit is operated in extremely elevated temperature
conditions, it is possible for internal and external metal
surfaces to become extremely hot.

EMC

The equipment has been tested and found to meet the CE-
regulations relating to EMC, and complies with the limits
for a Class B device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection
against interference to radio communications in any
installation. The equipment generates, uses and can radiate
radio frequency energy; improper use or special circumstances
may cause interference to other equipment or a performance
decrease due to interference radiated by other equipment. In
such cases, the user will have to take appropriate measures to
reduce such interactions between this and other equipment.

Any interruption of the shielding inside or outside the
equipment could cause the equipment to be more prone to fail
EMC requirements.

Non-video signal lines must use appropriate shielded CAT5
cabling (S-FTP), or at least an equivalent.
If system components, such as cabling (e.g. coaxial cable,
data/audio/cc wiring) and/or the units, are used outdoors,
ensure that

all

electrically connected components are

carefully earthed and protected against surges (high voltage
transients caused by switching or lightning).

ESD

Electrostatic discharge (ESD) can damage or destroy
electronic components. Proper precautions should be
taken against ESD when opening the equipment.

SELV: conforming to IEC 60950-1, <60V

output, output

voltage galvanically isolated from mains. All power supplies or
power supply cabinets available from Optelecom-NKF comply
with these SELV requirements.

14. Technical specifications

XSNet2800 SW

2800/SM-

10 BiDi

2800/SM-

60,

/CWDM-

2800

/MM

Optical

Optical ports

2 x 100/1000 Base-FX