Optec, Inc.
199 Smith Street ∙ Lowell, Michigan 49331 ∙ U.S.A.
www.optecinc.com
Page
25
of
29
Revision 10 –8/31/2012
3.
Plug 2 pos short cable between either 2 pos connector on the controller and the 2 pos
receptacle on the HV supply.
4.
Connect the USB cable between the Flat-Man XL controller and the computer or a
self-powered USB hub.
5.
Plug the 10 foot gray cable's white 2 pos plug into the remaining controllers's 2 pos
receptacle
and the round brown connector into the panel. Align the white dot on the
round plug with the dot on the panel receptacle. Gently push the plug on and rotate
the plug shell ¼-turn until you feel it click. Reverse this procedure to remove.
Do
not twist the connector by more than ¼-turn
. Be careful not to impact or bend the
connector while mated.
6.
Plug the power supply into the AC mains. NOTE: We have found that the power cord
fits very tightly into the connector on the back of the 600N inverter. You must use
considerable force to insert it completely to prevent intermittent connection. When
inserted properly there should be no more than 1/8" (3.5mm) gap between the
receptacle and the body of the cable connector.
7.
Download and run the application installer. You can download it from
www.alnitakastro.com/support/downloads
8.
Turn on the power supply using the power rocker switch on the back.
9.
Start the Windows Alnitak Controller application by clicking the Alnitak Controller
icon on the desktop.
10.
Connect to the device by selecting it from the list and clicking “Connect.”
11.
Click the “TURN ON” button and adjust the slider to your chosen value.
12.
Click the “TURN OFF” button to turn off light.
