Optec, Inc.
199 Smith Street ∙ Lowell, Michigan 49331 ∙ U.S.A.
www.optecinc.com
Page
15
of
29
Revision 10 –8/31/2012
the user must select one before clicking this button. You may also just double
click the desired device in the list.
CLOSE / OPEN
Button (Flip-Flat Only)
When clicked, the OPEN / CLOSE button causes the Flip-Flat cover to open or
close. The button label will alternate depending on the state of the cover. Note,
this option will not be available for flat-fielding devices other than the Flip-Flat.
HALT / RESUME
Button (Flip-Flat Only)
If the HALT button is clicked while the cover is moving, it will stop immediately.
The button label then changes to RESUME which, when clicked will restart the
cover in the same direction it was moving before the HALT button was clicked.
TURN / TURN OFF
Button
Clicking the TURN ON button, when enabled will turn on the flat light source.
This button is only enabled while the cover is closed. When the light is on, the
button label changes to TURN OFF. Clicking it then turns off the light source. If
the OPEN button is clicked while the light is on, the light will turn off and the
TURN ON button will become disabled until the cover is closed again,
BRIGHTNESS Slider
The brightness slider adjusts the brightness of the light. You can also use the up
and down arrows to fine tune the brightness. The slider is enabled or disabled
along with the TURN ON / TURN OFF button depending the state of the cover.
About
Clicking the About button in the menu bar opens an About menu that shows
information about the controller application as well as the version numbers of the
Flip-Flat firmware and the Flip-Flat Library used to create the controller
application.
QUIT
Clicking the QUIT button causes the application to exit.
