Support and Manuals
9 / 27
7.
Press the Mode button once. The Armed and Power LEDs ought to be radiant at this point. If this
is not the case, go to the "Troubleshooting" section of the user's manual.
8.
Now the laser head will be tested. Press the MOD button continuously for approximately 2
seconds. A short laser pulse (at full power), lasting for just about 1 seconds, will be generated.
This procedure will verify whether the laser head is connected in a correct fashion. If it doesn't
work, go to the "Troubleshooting" section.
9.
Once the laser has been connected properly, and the procedure described above has been
concluded without any issues, you can start engraving and cutting using your CNC machine with
the laser head attached.
Summary of Contents for PLH3D-6W-XF
